Pubic Hair Patch

Approximately 8 cm in length and 8 cm in width.

Step 1: Test Fit Before Trimming
After receiving the product, place it in position without using any adhesive to check the size. If it's too large, carefully trim the upper edge with scissors to your desired size.

Step 2: Apply with Adhesive

• Shave the area where the product will be applied.
• Apply a thin layer of adhesive to both the product and your skin. Avoid using too much, as excess glue may cause clumping. If this happens, soak the product in alcohol to remove the glue.
• Make sure the edges are fully coated. Wait until the glue becomes sticky and forms strings before attaching the product.
• Press firmly with a damp cloth or towel, following the direction of the hair to avoid damaging the product.

Step 3: Apply with Double-Sided Tape

• Attach double-sided tape to the back of the product.
• Shave the application area and press the product firmly into place.
• Note: The tape becomes stronger over time. It may not feel very secure at first but will hold firmly after a few hours.

Step 4: Removing the Product

• For adhesive: Use alcohol around the edges. Wait a few seconds until the product loosens, then gently remove.
• For tape: Apply adhesive remover onto the product, wait a few seconds, then remove.

Step 5: Aftercare

• Use alcohol to clean any residue left on your skin, then wash with facial cleanser or body wash.
• To clean the product, remove adhesive residue with alcohol (use adhesive remover for tape residue) and let it dry completely before storage.